Holland-electronics DST-5000 Manual de usuario descargar pdf (Pagina 10)

2.1.5 To store the measured values, use the / keys to select a desired

memory station (1-50) on the display. Then press the MR Key for 2 seconds

to store the measurement data into the designated station memory

location.

The letter “M” will be displayed in the upper right corner of the screen to

indicate stored values in the designated station memory location. Old

data must be cleared from a station by pressing and holding the MC Key

for 5 seconds before new measured values can be saved.

The stored data in all fifty memory locations can be cleared in a single

operation by pressing both the MC Key and the STKey for 5 seconds.

3. CABLE ID MODE:

In this mode, the receiver can be used to identify unidentifed cables by

attaching specially marked terminators (Holland p/n PFTK) to one end of

each cable. The meter can read the terminator resistance and display the

specific ID of the terminator corresponding to the chart below:

3.1 Press the MODE key to select Cable ID mode. The LCD will display as shown

below:

Resistance ohms Cable ID Display

0 ~ 210 SHORT 11K ~ 11.99K 11

220 ~ 990 -- -- 12K ~ 12.99K 12

1K ~ 1.99K 1 13K ~ 13.99K 13

2K ~ 2.99K 2 14K ~ 14.99K 14

3K ~ 3.99K 3 15K ~ 15.99K 15

4K ~ 4.99K 4 16K ~ 16.99K 16

5K ~ 5.99K 5 17K ~ 17.99K 17

6K ~ 6.99K 6 18K ~ 18.99K 18

7K ~ 7.99K 7 19K ~ 19.99K 19

8K ~ 8.99K 8 20K ~ 24.5K 20

9K ~ 9.99K 9 24.5K ~  OPEN

10K ~ 10.99K 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Sin comentarios

Holland-electronics DST-5000 Manual de usuario Pagina 10